ARCHIVE
august 2019
july 2019
june 2019
may 2019
april 2019
march 2019
february 2019
january 2019
december 2018
november 2018
october 2018
september 2018
august 2018
july 2018
april 2018
march 2018
february 2018
january 2018
december 2017
november 2017
october 2017
september 2017
august 2017
july 2017
june 2017
may 2017
april 2017
march 2017
february 2017
january 2017
december 2016
november 2016
october 2016
september 2016
august 2016
july 2016
june 2016
may 2016
april 2016
march 2016
february 2016
january 2016
december 2015
november 2015
october 2015
september 2015
august 2015
july 2015
june 2015
may 2015
april 2015
march 2015
february 2015
january 2015
december 2014
november 2014
october 2014
september 2014
august 2014
july 2014
june 2014
may 2014
april 2014
march 2014
february 2014
january 2014
december 2013
november 2013
october 2013
september 2013
august 2013
july 2013
june 2013
may 2013
april 2013
march 2013
february 2013
january 2013
april 2011

Anti-sticking junctions for the safety valve

Installation of a safety valve inside the plant in order to ensure its integrity

The pressure limitation on those plants where elevated temperatures might be reached is of fundamental importance for safeguarding the integrity of both the persons and the plant itself. To that end, a safety valve enabling the excess pressure to be discharged is usually inserted at a point that lies immediately downstream of the generator’s output.
Calibrated in a laboratory, the safety valve guarantees its intervention when it is subjected to too high a stimulation, by discharging part of the fluid contained in the plant and bringing it back to a safe condition. The fluid discharged by this action will then be reinstated into the pipes, a task usually entrusted to a filling device.
One of the peculiarities of every safety valve produced by GNALI BOCIA is to guarantee the restraint, i.e. its action is only carried out in the event of a marked excess over the calibration process, thereby avoiding the continuous drip system of the plant.
In order to ensure a constant operation over time, the sealing junction of the safety valve is realized in a special synthetic rubber capable of avoiding pasting, being a phenomenon which might dangerously shift the calibration point upwards.
Within the range of these items, there are also models with a manual control lever for draining the plant, being an operation demanded in special cases.

14/05/2015


See also
14/02/2015 Safety valves are necessary for your own protection Protect your system against damages by using a safety valve to be applied to the output of your generator.

14/09/2016 Safety valve for boiler approved in accordance with the PED directive Safety valve for boiler made in brass on numerical control machines at the Lumezzane plants

14/03/2016 In the event of an emergency, the shut-off valve comes into operation Shut-off valves and security valves prevent damages to the thermic system.

14/09/2014 System safety with the boiler safety valve Prevent problems and damages to your system by using a boiler safety valve

14/05/2014 Interception valves and I.S.P.E.S.L. standards The interception valve requirements are defined in the ISPESL standards


I contenuti di questo sito non hanno carattere di periodicità e non rappresentano 'prodotto editoriale'.